Table of Contents
Advertisement
Interfaces
4. Create the WWAN interfaces:
In this example, we will create two interfaces named WWAN_Public and WWAN_Private.
a. Click Network > Interfaces.
b. For Add Interface, type WWAN_Public and click .
c. For Interface type, select Modem.
d. For Zone, select External.
e. For Device, select Modem .
f. (Optional): Configure the public APN. If the public APN is not configured, the Connect EZ
will attempt to determine the APN.
i. Click to expand APN list > APN.
ii. For APN, type the public APN for your cellular carrier.
g. For Add Interface, type WWAN_Private and click .
h. For Interface type, select Modem.
i. For Zone, select External.
j. For Device, select Modem .
This should be the same modem selected for the WWAN_Public WWAN.
k. Enable APN list only.
l. Click to expand APN list > APN.
m. For APN, type the private APN provided to you by your cellular carrier.
5. Create the routing policies. For example, to route all traffic from LAN1 through the public APN,
and LAN2 through the private APN:
a. Click Network > Routes > Policy-based routing.
b. Click the to add a new route policy.
c. For Label, enter Route through public APN.
Digi Connect EZ 4/4i User Guide
Wide Area Networks (WANs)
93
Advertisement
Table of Contents
