Table of Contents
Advertisement
Central management
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
15. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Collect device health data and set the sample interval
You can enable or disable the collection of device health data to upload to Digi Remote Manager, and
configure the interval between health sample uploads. By default, device health data upload is
enabled, and the health sample interval is set to 60 minutes.
To avoid a situation where several devices are uploading health metrics information to Remote
Manager at the same time, the Connect EZ device includes a preconfigured randomization of two
minutes for uploading metrics. For example, if Health sample interval is set to five minutes, the
metrics will be uploaded to Remote Manager at a random time between five and seven minutes.
To disable the collection of device health data or enable it if it has been disabled, or to change the
health sample interval:
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Monitoring > Device Health.
4. (Optional) Click to expand Data point tuning.
Data point tuning options allow to you configure what data are uploaded to the Digi Remote
Manager. All options are enabled by default.
5. Only report changed values to Digi Remote Manager is enabled by default.
When enabled:
The device only reports device health metrics that have changed health metrics were
n
last uploaded. This is useful to reduce the bandwidth used to report health metrics.
All metrics are uploaded once every hour.
n
Digi Connect EZ 4/4i User Guide
Collect device health data and set the sample interval
807
Advertisement
Table of Contents
