Table of Contents
Advertisement
System administration
b. Log into the Connect EZ:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
When you first log into the WebUI or the command line, you will be required the change
the SSID and pre-shared key (password) for the preconfigured Wi-Fi access point before
you can save any configuration changes. See
preconfigured Wi-Fi access point
c. (Optional) Reset the default password for the admin account. See
password for the admin user
Reset the device with the revert command
You can reset the device to the default configuration without removing scripts, keys, and logfiles by
using the revert command:
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, enter revert:
(config)> revert
(config)>
4. Set the password for the admin user prior to saving the changes:
(config)> auth user admin password pwd
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the Connect EZ device to use custom factory default
settings
You can configure your Connect EZ device to use custom factory default settings. This way, when you
erase the device's configuration, the device will reset to your custom configuration rather than to the
original factory defaults.
Digi Connect EZ 4/4i User Guide
Erase device configuration and reset to factory defaults
Reset default SSID and pre-shared key for the
for instructions.
for further information.
Change the default
767
Advertisement
Table of Contents
