Change The Default Hotspot Ssid - Digi Connect EZ 4 User Manual

Hotspot

Change the default hotspot SSID

Required configuration items
Enable default hotspot configuration. See
n
instructions.
An SSID for the hotspot.
n

WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Wi-Fi > Access points > Digi Hotspot AP (Wi-Fi1).
4. Change the default SSID, Digi Hotspot, to your preferred value.
5. Click Apply to save the configuration and apply the change.

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
Digi Connect EZ 4/4i User Guide
Enable hotspot using the default configuration
Hotspot configuration
for
269