Enable Service Discovery (Mdns) - Digi Connect EZ 4 User Manual

Services
5. Add Ethernet devices:
a. Use the ? to determine available devices:
(config network bond name)> ... network device ?
Additional Configuration
---------------------------------------------------------------------
-------
loopback
(config network bond name)>
b. Add a device:
(config network bond name)> add device /network/device/
(config network bond name)>
c. Repeat to add additional devices.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Enable service discovery (mDNS)

Multicast DNS mDNS is a protocol that resolves host names in small networks that do not have a DNS
server. You can enable the Connect EZ device to use mDNS.
Note This feature is enabled by default.

WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Service Discovery (mDNS).
4. Enable the mDNS service.
5. Click Access control list to configure access control:
Digi Connect EZ 4/4i User Guide
Enable service discovery (mDNS)
586