Show Ipsec Status And Statistics - Digi Connect EZ 4 User Manual

Hide thumbs Also See for Connect EZ 4:

Table of Contents

Virtual Private Networks (VPN)

12. Save the configuration and apply the change:

(config vpn ipsec tunnel ipsec_example connection_monitor target 0)> save

Configuration saved.

13. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Show IPsec status and statistics

1. Log into the Connect EZ WebUI as a user with Admin access.

2. On the menu, select Status > IPsec.

The IPsec page appears.

3. To view configuration details about an IPsec tunnel, click the  (configuration) icon in the

upper right of the tunnel's status pane.

Command line

1. Log into the Connect EZ command line as a user with Admin access.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. To display details about all configured IPsec tunnels, type the following at the prompt:

> show ipsec all

3. To display details about a specific tunnel:

> show ipsec tunnel ipsec1

Digi Connect EZ 4/4i User Guide

(config vpn ipsec tunnel ipsec_example surelink target 0)>

other_status value

(config vpn ipsec tunnel ipsec_example surelink target 0)>

where value is either up or down. For example, if other_status is set to

down, but the alternate interface is determined to be up, then this test will

---------------

Connect ez 4i