Table of Contents
Advertisement
Wi-Fi
Configure the Wi-Fi radio's channel
By default, the Wi-Fi radio is configured to automatically select the best channel to use with respect to
other Wi-Fi networks. You can configure a specific channel to use for the Wi-Fi radio by using the
following steps.
2.4 GHz band—Channels 1 to 11 are supported. Channels 12, 13, and 14 are not supported.
n
5 GHz band—By default, only non-Dynamic Frequency Selection (DFS) channels are supported.
n
You can also enable support for DFS channels in client mode. See
support DFS channels in client mode
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > WiFi.
4. For Channel, select the channel. Only channels appropriate for the band are displayed.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
Digi Connect EZ 4/4i User Guide
Configure the Wi-Fi radio's channel
for information about enabling DFS support.
Configure the Wi-Fi radio to
218
Advertisement
Table of Contents
