Digi Connect EZ 4 User Manual page 142

Interfaces
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create the LAN1 interface:
a. Add the interface:
(config)> add network interface LAN1
(config network interface LAN1)>
b. Configure the LAN1 interface:
i. Enter device ? to view available devices and the proper syntax.
(config network interface LAN1)> device ?
Device: The network device used by this network interface.
Format:
Current value:
(config network interface LAN1)> device
ii. Set the device for the LAN1 interface:
c. Configure the firewall zone for the LAN1 interface to internal:
(config network interface LAN1)> zone internal
(config network interface LAN1)>
Digi Connect EZ 4/4i User Guide
/network/device/eth1
/network/device/eth2
/network/bridge/LAN
/network/bridge/Example_bridge
/network/wireless/ap/digi_ap
/network/wireless/ap/Example_AP
If you are configuring a Wi-Fi enabled Connect EZW , set the device to
n
/network/bridge/Example_bridge.
(config network interface LAN1)> device
/network/bridge/Example_bridge
(config network interface LAN1)>
If you are configuring a non-Wi-Fi Connect EZ, set the device to
n
/network/device/eth1 .
(config network interface LAN1)> device /network/device/eth1
(config network interface LAN1)>
Local Area Networks (LANs)
142