Digi Connect EZ 4 User Manual page 111

Interfaces
b. See Configure SureLink active recovery to detect WAN/WWAN failures
about configuring active recovery.
7. (Optional) Configure IPv6 settings:
a. Enable IPv6 support:
(config network interface my_wan)> ipv6 enable true
(config network interface my_wan)>
b. Set the IPv6 type to DHCP:
(config network interface my_wan)> ipv6 type dhcpv6
(config network interface my_wan)>
c. Generally, the default settings for IPv6 support are sufficient. You can view the default IPv6
settings by using the question mark (?):
(config network interface my_wan)> ipv6 ?
IPv6
Parameters
---------------------------------------------------------------------
----------
dhcp_hostname
enable
metric
mgmt
mtu
type
use_dns
weight
Additional Configuration
---------------------------------------------------------------------
----------
connection_monitor
(config network interface my_wan)>
d. Modify any of the remaining default settings as appropriate. For example, to change the
metric:
(config network interface my_wan)> ipv6 metric 1
(config network interface my_wan)>
If the minimum length is not available, then a longer prefix will be used.
See Configure WAN/WWAN priority and default route metrics
metrics.
Digi Connect EZ 4/4i User Guide
See Configure system information
n
EZ device's system name.
for information about setting the Connect
Current Value
false DHCP Hostname
true Enable
0 Metric
0 Management priority
1500 MTU
dhcpv6 Type
always Use DNS
10 Weight
Active recovery
Wide Area Networks (WANs)
for information
for further information about
111