Digi Connect EZ 4 User Manual page 284

Hotspot
Note Hotspot bridges must also be part of an interface with a configured IP address.
a. Create a bridge:
(config)> add network bridge new_hotspot_bridge
(config network bridge new_hotspot_bridge)>
b. Add devices to the bridge:
i. Determine available devices:
(config network bridge new_hotspot_bridge)> .. .. interface lan
device ?
Default value: /network/lan
Current value: /network/lan
(config network bridge new_hotspot_bridge)>
ii. Add the appropriate device. For example, to add the Digi AP Wi-Fi access point:
(config network bridge new_hotspot_bridge)> add device end
/network/wireless/ap/digi_ap
(config)>
c. Type ... to return to the config prompt:
(config network bridge new_hotspot_bridge)> ...
(config)>
d. Create an interface for the bridge:
(config)> add network interface hotspot_bridge_interface
(config network interface hotspot_bridge_interface)>
e. Add the new bridge to the interface:
(config network interface hotspot_bridge_interface)> device
/network/bridge/new_hotspot_bridge
(config network interface hotspot_bridge_interface)>
f. Set an IP address for the interface.
Note This IP address is not the IP address of the hotspot. The hotspot IP address is
configured during hotspot configuration.
(config network interface hotspot_bridge_interface)> ipv4 address ip_
address/netmask
(config network interface hotspot_bridge_interface)>
Digi Connect EZ 4/4i User Guide
Hotspot configuration
284