Digi Connect EZ 4 User Manual page 522

Services

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the SNMP agent:
(config)> service snmp enable true
(config)>
4. Configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service snmp acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the SNMP service.
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add service snmp acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the SNMP service.
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the Connect EZ
n
device:
(config)> add service snmp acl interface end value
(config)>
Where value is an interface defined on your device.
Digi Connect EZ 4/4i User Guide
Simple Network Management Protocol (SNMP)
522