Digi Connect EZ 4 User Manual page 640

Applications
]
},
"properties": {
"direction": "None",
"horizontal_velocity": "0.0",
"latitude.deg_min_sec": "44* 54' 45.586\" N",
"longitude.deg_min_sec": "93* 33' 52.334\" W",
"num_satellites": "12",
"quality": "Standard GNSS (2D/3D)",
"selected_source_idx": "0",
"source": "USB (/dev/ttyACM0)",
"source_idx.0.altitude": "273.200012",
"source_idx.0.direction": "None",
"source_idx.0.horizontal_velocity": "0.195489",
"source_idx.0.label": "usb",
"source_idx.0.latitude": "44.902662",
"source_idx.0.latitude.deg_min_sec": "44* 55' 45.065\" N",
"source_idx.0.longitude": "-93.560648",
"source_idx.0.longitude.deg_min_sec": "93* 16' 52.966\" W",
"source_idx.0.num_satellites": "12",
"source_idx.0.quality": "Standard GNSS (2D/3D)",
"source_idx.0.utc_date_time": "Mar-03-2022 10:16:23",
"source_idx.0.vertical_velocity": "0.0",
"source_idx.1.label": "gnss",
"source_idx.1.quality": "No Fix / Invalid",
"state": "Enabled, signal",
"utc_date_time": "Mar-03-2022 10:16:23",
"vertical_velocity": "0.0"
}
}
>>>
6. Use Ctrl-D to exit the Python session. You can also exit the session using exit() or quit().
Help for the digidevice location module
Get help for the digidevice location module:
1. Log into the Connect EZ command line as a user with shell access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type shell to access the device shell.
2. At the shell prompt, use the python command with no parameters to enter an interactive
Python session:
# python
Python 3.6.13 (default, May
[GCC 8.3.0] on linux
Digi Connect EZ 4/4i User Guide
44.926195299999998,
-93.397084499999999,
273.20001200000002
9 2021, 22:49:59)
Digidevice module
640