Table of Contents
Advertisement
Hardware
1. Insert your activated SIM card into the CORE module. The notched end of SIM card should be
inserted first, with the gold metal contacts facing down. You will hear a click once the SIM is
completely inserted.
Note
If one SIM card is being used, insert the SIM card into the SIM 1 slot.
2. Insert the CORE module into the device.
a. Orient the device so the front of the device is facing you.
b. Unscrew the CORE module slot cover from the back of the device.
c. Insert the CORE module into the slot. Make sure the pin holes on the back of the module
match the location of the pins in the slot.
d. Push the module into the slot.
e. Push the white handle down until you hear it click.
f. Optionally, you can screw one of the CORE module cover screws into the center of the
handle.
g. Place the white CORE module cover over the end of the device. Make sure that the
antenna labels are oriented correctly.
h. Push the cover in place.
3. Attach both of the included cellular antennas. While gripping the metal connector section with
your thumb and forefinger, tighten until secure. Do not tighten the antenna by holding any
part of the plastic antenna housing.
NEXT STEP: After you have connected the hardware, proceed to the next step:
connect to a cellular
Connect hardware and connect to a cellular network
This section explains how to connect the Connect EZ hardware and then connect to a cellular
network, using a CORE module. You must have purchased a CORE module to be able to connect to the
cellular network.
Note
As an alternative, you can also use an Ethernet LAN connection. See
using an Ethernet
To connect the hardware and connect to the cellular network:
1. Insert a CORE module with an activated SIM card. See
module.
2. Plug the power supply cord into at least one of the power supplies on the back of the device.
The second power cord can also be plugged in, but it is not required. It is available for power
redundancy.
3. Plug the power supply unit into an AC power outlet to power up the Connect EZ.
Mount the Connect EZ device
There are two mounting options available:
Digi Connect EZ 4/4i User Guide
network.
LAN.
Mount the Connect EZ device
Connect hardware and
Connect to site network
Cellular connection: Insert the CORE
36
Advertisement
Table of Contents
