Digi Connect EZ 4 User Manual page 253

Wi-Fi
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new Wi-Fi client:
(config)> add network wifi client new_client
(config network wifi client new_client)>
New clients are enabled by default.
4. Configure the Wi-Fi network that the client will use:
a. Set the SSID of the access point that the client will use to connect to the Wi-Fi network:
(config network wifi client new_client)> ssid 0 ssid value
(config network wifi client new_client)>
where value is the SSID of the access point.
b. Set the encryption type for the access point:
(config network wifi client new_client)> ssid 0 encryption type value
(config network wifi client new_client)>
where value is the type of encryption used by the access point. Allowed values are:
n
n
n
n
n
n
n
n
c. If the type of encryption is set to:
n
Digi Connect EZ 4/4i User Guide
none: no encryption.
owe: WPA3 Enhanced Open, which uses Opportunistic Wireless Encryption (OWE)
technology to provide encryption for Wi-Fi networks that do not use password
protection.
psk: WPA personal encryption.
mixedpsk: Uses both WPA and WPA2 personal encryption.
psk2: WPA2 personal encryption.
psk2sae: Uses WPA2-PSK/WPA3-AES mixed mode.
sae: Uses WPA3 Personal mode.
wpa2: WPA2 enterprise encryption.
psk, mixedpsk, psk2, psk2sae, or sae, set the password that the client will use to
connect to the access point:
(config network wifi client new_client)> ssid 0 encryption key_
psk2 password
(config network wifi client new_client)>
Configure a Wi-Fi client and add client networks
253