Table of Contents
Advertisement
Services
Configure SSH access
The Connect EZ's default configuration has SSH access enabled, and allows SSH access to the device
from authorized users within the Internal firewall zone. If this configuration is sufficient for your
needs, no further configuration is required. See
for information about configuring the SSH service to allow access from remote devices.
Required configuration items
Enable SSH access.
n
Configure access control for the SSH service.
n
Additional configuration items
Port to use for communications with the SSH service.
n
Multicast DNS (mDNS) support.
n
A private key to use for communications with the SSH service.
n
Create custom SSH configuration settings.
n
See
Set the idle timeout for Connect EZ users
the SSH service.
Enable or disable the SSH service
The SSH service is enabled by default. To disable the service, or enable it if it has been disabled:
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > SSH.
4. Click Enable.
5. Click Apply to save the configuration and apply the change.
Command line
Digi Connect EZ 4/4i User Guide
Allow remote access for web administration and SSH
for information about setting the inactivity timeout for
Configure SSH access
500
Advertisement
Table of Contents
