Table of Contents
Advertisement
Wi-Fi
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the channel for the radio:
a. Determine the band for the radio:
(config)> network wifi radio phy0 band
2400mhz
(config)>
b. Set the channel for the Wi-Fi radio:
(config)> network wifi radio phy0 2400mhz channel value
(config)>
where value is:
n
n
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the Wi-Fi radio to support DFS channels in client mode
Dynamic Frequency Selection (DFS) is a mechanism for Wi-Fi connections to use 5 GHz frequencies
that are normally reserved for non-Wi-Fi proposes. In addition to the standard non-DFS channels (36,
40, 44, and 48), your Connect EZ can be configured to have one or more Wi-Fi clients that can connect
to external Wi-Fi access points that support DFS channels:
DFS channels 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140, and 144
n
Higher 5GHz non-DFS channels 149, 153, 157, 161, and 165
n
The Wi-Fi access point must also support connections on these channels.
Digi Connect EZ 4/4i User Guide
Configure the Wi-Fi radio to support DFS channels in client mode
For 2.4 GHz:
1 through 11
l
auto
l
For 5 GHz:
36
l
40
l
44
l
48
l
auto
l
219
Advertisement
Table of Contents
