Digi Connect EZ 4 User Manual page 315

Routing
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Routes > Static routes.
4. Click the menu icon (...) for a static route and select Delete.
5. Click Apply to save the configuration and apply the change.

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Determine the index number of the static route to be deleted:
(config)> show network route static
0
dst 10.0.0.1
enable true
no gateway
interface /network/interface/lan1
label new_static_route
metric 0
mtu 0
1
dst 192.168.5.1
enable true
gateway 192.168.5.1
interface /network/interface/lan2
label new_static_route_1
Digi Connect EZ 4/4i User Guide
IP routing
315