Table of Contents
Advertisement
User authentication
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable access rights for the group. For example:
Admin access:
n
To set the access level for Admin access of the admin group:
l
where value is either:
o
o
The default is full.
Digi Connect EZ 4/4i User Guide
(config)> auth group admin acl admin level value
(config)>
full: provides users of this group with the ability to manage the Connect EZ
device by using the WebUI or the Admin CLI.
read-only: provides users of this group with read-only access to the WebUI and
Admin CLI.
Authentication groups
660
Advertisement
Table of Contents
