Digi Connect EZ 4 User Manual page 597

Services
To limit access to hosts connected through a specified interface on the Connect EZ
n
device:
(config)> add service iperf acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service iperf acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to list additional firewall zones.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect EZ 4/4i User Guide
Display a list of available interfaces:
Use ... network interface ? to display interface information:
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Configure the ping responder service
597