Digi Connect EZ 4 User Manual page 483

Virtual Private Networks (VPN)
13. Click to expand Local networks.
a. For Add Interface, click  to add a local network to use as a virtual NEMO network
interface.
b. For Interface, select the local interface to use as a virtual NEMO network interface.
Generally, this will be the a Local Area Network (LAN).
c. (Optional) Repeat for additional interfaces.
14. Click Apply to save the configuration and apply the change.

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a NEMO tunnel. For example, to add a NEMO tunnel named nemo_example:
(config)> add vpn nemo nemo_example
(config vpn nemo nemo_example)>
The NEMO tunnel is enabled by default. To disable:
(config vpn nemo nemo_example)> enable false
(config vpn nemo nemo_example)>
4. Set the IPv4 address of the NEMO virtual network interface:
(config vpn nemo nemo_example)> home_address IPv4_address
(config vpn nemo nemo_example)>
5. Set the IPv4 address of the NEMO home agent. This is provided by your cellular carrier.
(config vpn nemo nemo_example)> home_agent IPv4_address
(config vpn nemo nemo_example)>
6. Set the key used to authenticate to the home agent. This is provided by your cellular carrier.
(config vpn nemo nemo_example)> key value
(config vpn nemo nemo_example)>
Digi Connect EZ 4/4i User Guide
NEMO
483