Digi Connect EZ 4 User Manual page 734

Firewall

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable custom firewall rules:
(config)> firewall custom enable true
(config)>
4. (Optional) Instruct the device to override all preconfigured firewall behavior and rely solely on
the custom firewall rules:
(config)> firewall custom override true
(config)>
5. Set the shell command that will execute the custom firewall rules script:
(config)> firewall custom rules "shell-command"
(config)>
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect EZ 4/4i User Guide
Configure custom firewall rules
734