Digi Connect EZ 4 User Manual page 232

Wi-Fi
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new access point:
(config)> add network wifi ap new_AP
(config network wifi ap new_AP)>
New access points are enabled by default.
4. Set the SSID for the Wi-Fi access point. Up to 32 characters are allowed.
(config network wifi ap new_AP)> ssid my_SSID
(config network wifi ap new_AP)>
SSID broadcasting is enabled by default for new access points.
5. Set the security for the access point to a personal security option:
(config network wifi ap new_AP)> encryption type value
(config network wifi ap new_AP)>
where value is one of:
psk: Uses WPA Personal (PSK). All Wi-Fi clients must support WPA to be able to
n
authenticate.
mixedpsk: Uses mixed WPA/WPA2 Personal (PSK) mode. Wi-Fi clients that support WPA
n
and WPA2 are able to authenticate.
psk2: Uses WPA2 Personal (PSK) mode. All Wi-Fi clients must support WPA2 to be able
n
to authenticate.
psk2sae: Uses WPA2-PSK/WPA3-AES mixed mode. Wi-Fi clients that support WPA2 and
n
WPA3 are able to authenticate.
sae: Uses WPA3 Personal mode. All Wi-Fi clients must support WPA3 to be able to
n
authenticate.
(config network wifi ap new_AP)> encryption type psk2sae
(config network wifi ap new_AP)>
6. (Optional) Determine whether to prevent clients that are connected to this access point from
communicating with each other:
(config)> network wifi ap digi_ap isolate_clients true
(config)>
See Isolate Wi-Fi clients
access points from communicating with each other.
Digi Connect EZ 4/4i User Guide
Configure a Wi-Fi access point with personal security
for information about how to prevent clients connected to different
232