Table of Contents
Advertisement
System administration
When you first log into the WebUI or the command line, you will be required the change
the SSID and pre-shared key (password) for the preconfigured Wi-Fi access point before
you can save any configuration changes. See
preconfigured Wi-Fi access point
c. (Optional) Reset the default password for the admin account. See
password for the admin user
Command line
1. Log into the Connect EZ command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the following:
> system factory-erase
3. After resetting the device:
a. Connect to the Connect EZ by using the serial port or by using an Ethernet cable to
connect the Connect EZ ETH2 port to your PC.
b. Log into the Connect EZ:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
When you first log into the WebUI or the command line, you will be required the change
the SSID and pre-shared key (password) for the preconfigured Wi-Fi access point before
you can save any configuration changes. See
preconfigured Wi-Fi access point
c. (Optional) Reset the default password for the admin account. See
password for the admin user
Reset the device by using the RESET button.
1. Locate the RESET button on your device.
2. Press the RESET button perform a device reset. The RESET button has the following modes:
Configuration reset:
n
Press and release the RESET button .
l
The device reboots automatically and resets to factory defaults. This does not
l
remove any automatically generated certificates and keys.
Full device reset:
n
After the device reboots from the first button press, immediately press and
l
releasethe RESET button again.
The device reboots again and resets to factory defaults, as well as also removing
l
generated certificates and keys.
3. After resetting the device:
a. Connect to the Connect EZ by using the serial port or by using an Ethernet cable to
connect the Connect EZ ETH2 port to your PC.
Digi Connect EZ 4/4i User Guide
Erase device configuration and reset to factory defaults
Reset default SSID and pre-shared key for the
for instructions.
for further information.
Reset default SSID and pre-shared key for the
for instructions.
for further information.
Change the default
Change the default
766
Advertisement
Table of Contents
