Digi Connect EZ 4 User Manual page 537

Services
6. Set the TCP or UDP port on the remote host to which location messages will be sent:
(config service location forward 0)> server_port 8000
(config service location forward 0)>
7. Set the number of Location update intervals to wait before forwarding location data to this
server. See
update interval.
(config service location forward 0)> interval_multiplier int
(config service location forward 0)>
8. Set the protocol type for the messages. Allowed values are taip or nmea; the default is taip:
(config service location forward 0)> type nmea
(config service location forward 0)>
(Optional) If the protocol type is set to nmea, configure a Talker ID.
n
The talker ID is a two-character prefix in the NMEA message that identifies the source
type. The talker ID set here will override the talker ID from all sources, and all
forwarded sentences will use the configured ID.
a. Use the ? to determine available talker IDs:
b. Set the talker ID:
The default setting is Default, which means that the talker ID provided by the source
will be used.
Digi Connect EZ 4/4i User Guide
Configure the location service
(config service location forward 0)> talker_id ?
Talker ID: Setting a talker ID will override the talker ID from
all remote
sources, and all forwarded sentences from remote sources will
use the configured
ID.
Format:
Default
GA
GB
GI
GL
GN
GP
GQ
Default value: Default
Current value: Default
(config service location forward 0)>
(config service location forward 0)> talker_id value
(config service location forward 0)>
for more information about setting the Location
Location information
537