Digi Connect EZ 4 User Manual page 340

Hide thumbs Also See for Connect EZ 4:

Table of Contents

11. Click Apply to save the configuration and apply the change.

Command line

1. Log into the Connect EZ command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Create a new VRRP instance, or edit an existing one. See

creating a new VRRP instance.

4. Enable VRRP+:

(config)> network vrrp VRRP_test vrrp_plus enable true

5. Add interfaces to monitor. Generally, this will be a cellular or WAN interface.

a. Use the ? to determine available interfaces:

b. Set the interface, for example:

(config)> add network vrrp VRRP_test vrrp_plus monitor_interface end

/network/interface/modem

c. (Optional) Repeat for additional interfaces.

6. Set the amount that the device's priority should be decreased or increased due to SureLink

connectivity failure or success:

(config)> network vrrp VRRP_test vrrp_plus weight value

Digi Connect EZ 4/4i User Guide

Virtual Router Redundancy Protocol (VRRP)

Configure VRRP

for information about

Connect ez 4i