Digi Connect EZ 4 User Manual page 75

Hide thumbs Also See for Connect EZ 4:
Table of Contents

Advertisement

Interfaces
For example, to set Interval to ten minutes, enter 10m or 600s.
The default is 15 minutes.
b. If more than one test target is configured, for Success condition, determine whether the
interface should fail over based on the failure of one of the test targets, or all of the test
targets.
c. For Pass threshold, type or select the number of times that the test must pass after
failure, before the interface is determined to be working and is reinstated.
d. For Failed attempts, type the number of probe attempts before the WAN is considered to
have failed.
e. For Response timeout, type the amount of time that the device should wait for a response
to a probe attempt before considering it to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Response timeout to ten minutes, enter 10m or 600s.
The default is 15 seconds.
13. (Optional) Repeat this procedure for IPv6.
14. Click Apply to save the configuration and apply the change.
  Command line
Active recovery can be configured for both IPv4 and IPv6. These instructions are for IPv4; to configure
IPv6 active recovery, replace ipv4 in the command line with ipv6.
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new interface, or edit an existing one:
To create a new interface, see
n
or
Configure a Wide Area Network (WAN)
(WWAN).
To edit an existing interface, change to the interface's node in the configuration
n
schema. For example, for a interface named my_wan, change to the my_wan node in
the configuration schema:
(config)> network interface my_wan
(config network interface my_wan)>
Digi Connect EZ 4/4i User Guide
Configure a
LAN,
Configure a Wide Area Network
or
Configure a Wireless Wide Area Network
Wide Area Networks (WANs)
(WAN),
75

Advertisement

Table of Contents
loading

This manual is also suitable for:

Connect ez 4i

Table of Contents