Digi Connect EZ 4 User Manual page 160

Interfaces
10. Save the configuration and apply the change:
(config network interface my_lan ipv4 dhcp_server advanced custom_option
0)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure DHCP relay
DHCP relay allows a router to forward DHCP requests from one LAN to a separate DHCP server,
typically connected to a different LAN.
For the Connect EZ device, DHCP relay is configured by providing the IP address of a DHCP relay
server, rather than an IP address range. If both the DHCP relay server and an IP address range are
specified, DHCP relay is used, and the specified IP address range is ignored.
Multiple DHCP relay servers can be provided for each LAN. If multiple relay servers are provided, DHCP
requests are forwarded to all servers without waiting for a response. Clients will typically use the IP
address from the first DHCP response received.
Configuring DHCP relay involves the following items:
Required configuration items
Disable the DHCP server, if it is enabled.
n
IP address of the primary DHCP relay server, to define the relay server that will respond to
n
DHCP requests.
Additional configuration items
IP address of additional DHCP relay servers.
n

WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Click to expand an existing LAN, or create a new LAN. See
5. Disable the DHCP server, if it is enabled:
a. Click to expand IPv4 > DHCP server.
b. Click Enable to toggle off the DHCP server.
6. Click to expand DHCP relay.
Digi Connect EZ 4/4i User Guide
Local Area Networks (LANs)
Configure a LAN.
160