Table of Contents
Advertisement
System administration
Configuration files
The Connect EZ configuration file, /etc/config/accns.json, contains all configuration changes that have
been made to the device. It does not contain the complete device configuration; it only contains
changes to the default configuration. Both the default configuration and the changes contained in the
accns.json file are applied when the device reboots.
Save configuration changes
When you make changes to the Connect EZ configuration, the changes are not automatically saved.
You must explicitly save configuration changes, which also applies the changes. If you do not save
configuration changes, the system discards the changes.
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Make any necessary configuration changes.
4. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Make any necessary configuration changes.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
Digi Connect EZ 4/4i User Guide
Configuration files
771
Advertisement
Table of Contents
