Digi Connect EZ 4 User Manual page 778

System administration
9. (Optional) Click to enable Configuration check to allow for the configuration to be updated,
including by custom scripts, during the maintenance window.
10. (Optional) Configure automated checking for device firmware updates:
a. Click to expand Firmware update check.
b. Device firmware update check is enabled by default. This enables to automated
checking for device firmware updates.
c. Modem firmware update check is enabled by default. This enables to automated
checking for modem firmware updates.
d. For Frequency, select how often automated checking for device and modem firmware
should take place. Allowed values are Daily, Weekly, and Monthly. The default is Daily.
11. Click Apply to save the configuration and apply the change.

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure a system maintenance trigger:
a. Add a trigger:
(config)> add system schedule maintenance trigger end
(config)>
b. Set the type of trigger:
(config add system schedule maintenance trigger)> type value
(config)>
where value is one of:
n
Digi Connect EZ 4/4i User Guide
interface_up: If interface_up is set:
i. Set the interface:
(config add system schedule maintenance trigger)> interface
value
(config)>
Schedule system maintenance tasks
778