Digi Connect EZ 4 User Manual page 98

Hide thumbs Also See for Connect EZ 4:
Table of Contents

Advertisement

Interfaces
6. Save the configuration and apply the change:
(config network route policy 1)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure manual carrier selection
By default, your Connect EZ automatically selects the most appropriate cellular carrier based on the
SIM that is in use and the status of available carriers in your area.
Alternately, you can configure the devices to manually select the carrier, based on the Network PLMN
ID. You can also configure the device to use manual carrier selection and fall back to automatic carrier
selection if connecting to the manually-configured carrier fails.
You can use also use the
and determine their PLMN ID.
Required configuration items
Select Manual or Manual/Automatic carrier selection mode.
n
The Network PLMN ID.
n
  WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. For Carrier selection mode, select one of the following:
Automatic—The device automatically selects the carrier based on your SIM and cellular
n
network status.
Manual—The device will only connect to the carrier identified in the Network PLMN ID.
n
If the carrier is not available, no cellular connection will be established.
Manual/Automatic—The device will attempt to connect to the carrier identified in the
n
Network PLMN ID. If the carrier is not available, the device will fall back to using
automatic carrier selection.
4. If Manual or Manual/Automatic are selected for Carrier section mode, enter the Network
PLMN ID.
Note
You can use
and determine their PLMN ID. See
Digi Connect EZ 4/4i User Guide
modem scan
command at the command line to scan for available carriers
themodem scan
command at the Admin CLI to scan for available carriers
Scan for available cellular carriers
Wide Area Networks (WANs)
for details.
98

Advertisement

Table of Contents
loading

This manual is also suitable for:

Connect ez 4i

Table of Contents