Telnet; Traceroute - Digi Connect EZ 4 User Manual

Command line interface
Test the configured NTP server(s) for connectivity. This test will not affect the device's current local
date and time.
Syntax
system time test
Parameters
None

telnet

Use Telnet protocol to log into a remote server.
Syntax
telnet <host> [port INTEGER]
Parameters
host: The hostname or IP address of the remote host.
port: The telnet port to use to connect to the remote host. (Minimum: 1, Maximum: 65535, Default: 23)

traceroute

Print the route packets trace to network host.
Syntax
traceroute <host> [ipv6] [gateway STRING] [interface STRING] [first_ttl
INTEGER] [max_ttl INTEGER] [port INTEGER] [nqueries INTEGER] [src_addr STRING]
[tos INTEGER] [waittime INTEGER] [pausemsecs INTEGER] [packetlen INTEGER]
[debug] [dontfragment] [icmp] [nomap] [bypass]
Parameters
host: The host that we wish to trace the route packets for.
ipv6: If a hostname is defined as the value of the 'host' parameter, use the hosts IPV6 address.
gateway: Tells traceroute to add an IP source routing option to the outgoing packet that tells the
network to route the packet through the specified gateway.
interface: Specifies the interface through which traceroute should send packets. By default, the
interface is selected according to the routing table.
first_ttl: Specifies with what TTL to start. (Minimum: 1, Default: 1)
max_ttl: Specifies the maximum number of hops (max time-to-live value) traceroute will probe.
(Minimum: 1, Default: 30)
port: Specifies the destination port base traceroute will use (the destination port number will be
incremented by each probe). A value of -1 specifies that no specific port will be used. (Minimum: -1,
Default: -1)
nqueries: Sets the number of probe packets per hop. A value of -1 indicated. (Minimum: 1, Default: 3)
src_addr: Chooses an alternative source address. Note that you must select the address of one of the
interfaces. By default, the address of the outgoing interface is used.
tos: For IPv4, set the Type of Service (ToS) and Precedence value. Useful values are 16 (low delay) and
8 (high throughput). Note that in order to use some TOS precedence values, you have to be super
Digi Connect EZ 4/4i User Guide
Command line reference
911