Digi Connect EZ 4 User Manual page 255

Wi-Fi
5. (Optional) Configure background scanning.
Background scanning allows the device to scan for nearby access points and to move between
access points that have the same SSID that is configured for the client connection, based on
the signal strength of the access points.
a. Enable background scanning:
(config network wifi client new_client)> background_scanning enable
true
(config network wifi client new_client)>
b. Set the scan threshold (bgscan_strength), in dB, that is used to determine the scanning
frequency.
Digi Connect EZ 4/4i User Guide
(config network wifi client new_client)> ssid 0
encryption scep_client SCEP_test_client
(config network wifi client new_client)>
See Configure a Simple Certificate Enrollment Protocol client
information about SCEP clients.
tls: Client certificate authentication. If tls is selected:
l
i. Set the username:
(config network wifi client new_client)> ssid 0
encryption id_wpa2 username
(config network wifi client new_client)>
ii. Set the CA certificate by using the ca_cert paramater and pasting the
certificte in PEM format:
(config network wifi client new_client)> ssid 0
encryption ca_cert certificate
(config network wifi client new_client)>
iii. Set the client certificate by using the client_cert paramater and
pasting the certificte in PEM format:
(config network wifi client new_client)> ssid 0
encryption client_cert certificate
(config network wifi client new_client)>
iv. Set the private key by using the private_key paramater and pasting
the private key in PEM format:
(config network wifi client new_client)> ssid 0
encryption private_key key
(config network wifi client new_client)>
v. (Optional) Set the private key passphrase:
(config network wifi client new_client)> ssid 0
encryption private_key_passphrase passphrase
(config network wifi client new_client)>
Configure a Wi-Fi client and add client networks
for
255