Digi Connect EZ 4 User Manual page 100

Hide thumbs Also See for Connect EZ 4:

Table of Contents

For devices using Unitac modems (such as devices with the 1002-CM45 core module), carrier

scanning will not work if the modem has an active cellular connection.

1. Log into the Connect EZ WebUI as a user with Admin access.

2. From the main menu, click Status > Modems.

3. Scroll to the Connection Status section and click SCAN.

The Carrier Scan window opens.

4. When the Carrier Scan window opens, the results of the most recent previous scan are

displayed. If there is no previous scan available, or to refresh the list, click SCAN.

5. The current carrier is highlighted in green. To switch to a different carrier:

a. Highlight the appropriate carrier and click SELECT.

The Carrier selection dialog opens.

b. For Carrier selection mode, select one of the following:

Command line

1. Log into the Connect EZ command line as a user with Admin access.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the Admin CLI prompt, type:

> modem scan

Issuing network scan, this may take some time...

Digi Connect EZ 4/4i User Guide

Manual/Automatic: The device will use automatic carrier selection if this carrier is

not available.

Manual: Does not allow the device to use automatic carrier selection if this carrier

is not available.

If Manual is selected, your modem must support the Network technology or

the modem will lose cellular connectivity. If you are using a cellular connection to

perform this procedure, you may lose your connection and the device will no longer

be accessible.

Wide Area Networks (WANs)

Connect ez 4i