Table of Contents
Advertisement
Command line interface
Parameters
None
show wifi-scanner candidates
Show transmitters detected during the most recent observation period but not evaluated as static.
Syntax
show wifi-scanner candidates
Parameters
None
show wifi-scanner log
Show output log for the last update interval.
Syntax
show wifi-scanner log
Parameters
None
speedtest
Perform a speed test to a remote host using nuttcp or iPerf. The system's primary default route will be
used. The speed test will take approximately 30 seconds to complete.
Syntax
speedtest <host> [size INTEGER] [mode <nuttcp|iperf>] [output <text|json>]
Parameters
host: The name or address of the remote speed test host/server.
size: The number of kilobytes sent in the speed test packets. (Minimum: 0, Default: 1000)
mode: The type of speed test protocol to run. (Default: nuttcp)
output: The format of output to display the speed test results as. (Default: text)
ssh
Use SSH protocol to log into a remote server.
Syntax
ssh <host> <user> [port INTEGER] [command STRING]
Parameters
host: The hostname or IP address of the remote host.
user: The username to use when connecting to the remote host.
Digi Connect EZ 4/4i User Guide
Command line reference
905
Advertisement
Table of Contents
