Digi Connect EZ 4 User Manual page 135

Interfaces
d. The authentication server port number defaults to 1812. To set an alternate port number:
(config network interface my_lan)> 802_1x authentication port port
(config network interface my_lan)>
e. Set the frequency period for reauthorization:
(config network interface my_lan)> 802_1x authentication reauth_period
value
(config network interface my_lan)>
where value is an integer between 0 and 86400. The default is 3600.
f. (Optional) Configure 802.1x authentication auditing:
i. Enable authentication auditing on the Connect EZ device:
(config network interface my_lan)> 802_1x accounting enable true
(config network interface my_lan)>
ii. Set the IP address of the accounting server:
(config network interface my_lan)> 802_1x accounting ip IPv4_
address
(config network interface my_lan)>
iii. Set the password for the accounting server:
(config network interface my_lan)> 802_1x accounting password
password
(config network interface my_lan)>
iv. The accounting server port number defaults to 1813. To set an alternate port number:
(config network interface my_lan)> 802_1x accounting port port
(config network interface my_lan)>
9. (Optional) Configure the MAC address deny list.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address denylist.
a. Add a MAC address to the denylist:
(config network interface my_lan)> add mac_denylist end mac_address
(config network interface my_lan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MAC address.
10. (Optional) Configure the MAC address allowlist.
If allowlist entries are specified, incoming packets will only be accepted from the listed MAC
addresses.
Digi Connect EZ 4/4i User Guide
Local Area Networks (LANs)
135