Delete A Wan Or Wwan - Digi Connect EZ 4 User Manual

Interfaces
IPv6 Metric
IPv6 Weight
IPv6 DNS Server(s)
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Delete a WAN or WWAN

Follow this procedure to delete any WANs and WWANs that have been added to the system. You
cannot delete the preconfigured WAN, ETH1, or the preconfigured WWAN, Modem.

WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Click the menu icon (...) next to the name of the WAN or WWAN to be deleted and select
Delete.
5. Click Apply to save the configuration and apply the change.

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
Digi Connect EZ 4/4i User Guide
: 1
: 10
: fd00:244::1, fe80::234:f3f4:fe0e:4320
Wide Area Networks (WANs)
125