Digi Connect EZ 4 User Manual page 280

Hotspot
Note
configured during hotspot configuration.
5. Click Network > Hotspots.
6. For Add Hotspot, enter a name for the hotspot and click .
The new hotspot configuration appears.
7. Hotspots are enabled by default when they are created. To disable, click Enable hotspot.
8. For Zone, leave at the default setting of hotspot. The hotspot firewall zone provides the
necessary firewall rules for hotspot functionality.
9. For Device, select an access point, and Ethernet port, or a bridge.
10. For Authentication Mode, select one of the following:
Click-through: Requires each user to accept the terms and conditions.
n
Local shared password: Requires each user to enter a password. This password is
n
validated locally on the Connect EZ device, and the password is the same for all users.
See
about configuring hotspot for local shared password authentication.
RADIUS shared password: Requires each user to enter a password. This password is
n
validated by an external RADIUS server, and the password is the same for all users.
See
information about configuring hotspot for RADIUS shared password authentication.
RADIUS users: Requires each user to enter username and password credentials that are
n
established on an external RADIUS server. The credentials are validated by the RADIUS
server.
Digi Connect EZ 4/4i User Guide
This IP address is not the IP address of the hotspot. The hotspot IP address is
Configure the hotspot to use local shared password authentication
Configure the hotspot to use RADIUS shared password authentication
Hotspot configuration
for information
for
280