Nemo - Digi Connect EZ 4 User Manual

Virtual Private Networks (VPN)
1. Log into the Connect EZ command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured L2TPv3 Ethernet tunnels, type the following at the
prompt:
> show l2tpeth
Tunnel Session
-----------------
test/session/test
>
3. To display details about a specific tunnel:
> show l2tpeth name /vpn/l2tpeth/test/session/test
test/session/test Tunnel Session Status
---------------------------------------
Enabled
Status
Local IP
Remote IP
Tunnel ID
Peer Tunnel ID
Session ID
Peer Session ID
Lifetime (Actual)
Device
RX Packets
RX Bytes
TX Packets
TX Byptes
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

NEMO

Network Mobility (NEMO) is a mobile networking technology that provides access to one or more
Local Area Networks (LANs) on your device. NEMO creates a tunnel between the home agent on the
mobile private network and the Connect EZ device, isolating the connection from internet traffic and
advertising the IP subnets of the LANs for remote access and device management.
Dynamic Mobile Network Routing (DMNR) is the implementation of NEMO for Verizon Wireless Private
Networks. DMNR support requires the use of Verizon SIM cards that have DMNR enabled.
Digi Connect EZ 4/4i User Guide
Enabled Device
------- ------------
true le_test_test
: true
: up
: 4.3.2.1
: 10.10.10.1
: modem
: 10.10.10.1 === 4.3.2.1
: 255
: 1476
: 600
: le_test_test
: 2,102
: 462
: 2,787
: 3,120
Status
------
up
NEMO
480