Digi Connect EZ 4 User Manual page 268

Hotspot

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the hotspot:
(config)> network hotspot hotspot enable true
(config)>
4. Enable the hotspot access points:
5. Enable the hotspot bridge:
(config)> network bridge hotspot_bridge enable true
(config)>
6. Enable the hotspot LAN:
(config)> network interface lan_hotspot enable true
(config)>
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect EZ 4/4i User Guide
Hotspot configuration
268