Digi Connect EZ 4 User Manual page 134

Interfaces
connection_monitor
dhcpv6_server
(config network interface my_lan)>
View default settings for the IPv6 DHCP server:
(config network interface my_lan)> ipv6 dhcpv6_server ?
DHCPv6 server: The DHCPv6 server settings for this network interface.
Parameters
---------------------------------------------------------------------
----------
enable
(config network interface my_lan)>
d. Modify any of the remaining default settings as appropriate. For example, to change the
minimum length of the prefix:
(config network interface my_lan)> ipv6 prefix_length 60
(config network interface my_lan)>
If the minimum length is not available, then a longer prefix will be used.
See Configure WAN/WWAN priority and default route metrics
metrics.
8. (Optional) To configure 802.1x port based network access control:
Note The Connect EZ can function as an 802.1x authenticator; it does not function as an 802.1x
supplicant.
a. Enable the 802.1x authenticator on the Connect EZ device:
(config network interface my_lan)> 802_1x authentication enable true
(config network interface my_lan)>
b. Set the IP address of the authentication server:
(config network interface my_lan)> 802_1x authentication ip IPv4_
address
(config network interface my_lan)>
c. Set the password for the authentication server:
(config network interface my_lan)> 802_1x authentication password
password
(config network interface my_lan)>
Digi Connect EZ 4/4i User Guide
Active recovery
DHCPv6 server
Current Value
true Enable
Local Area Networks (LANs)
for further information about
134