Table of Contents
Advertisement
Services
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the mDNS service:
(config)> service mdns enable true
(config)>
4. Configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service mdns acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the mDNS service.
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add service mdns acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the mDNS service.
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the Connect EZ
n
device:
(config)> add service mdns acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service mdns acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Digi Connect EZ 4/4i User Guide
Display a list of available interfaces:
Use ... network interface ? to display interface information:
Display a list of available firewall zones:
Enable service discovery (mDNS)
588
Advertisement
Table of Contents
