Delete A Static Route - Digi Connect EZ 4 User Manual

Routing
For example, to route traffic to the 192.168.47.0 network that uses a subnet mask of
255.255.255.0:
(config network route static 0)> dst 192.168.47.0/24
(config network route static 0)>
The any keyword can also be used to route packets to any destination with this static route.
6. Set the interface on the Connect EZ device that will be used with this static route:
a. Use the ? to determine available interfaces:
b. Set the interface. For example:
(config network route static 0)> interface /network/interface/eth1
(config network route static 0)>
7. (Optional) Set the IPv4 address of the gateway used to reach the destination. Set to blank if
the destination can be accessed without a gateway.
(config network route static 0)> gateway IPv4_address
(config network route static 0)>
8. (Optional) Set the metric for the route. When multiple routes are available to reach the same
destination, the route with the lowest metric is used.
(config network route static 0)> metric value
(config network route static 0)>
where value is an interger between 0 and 65535. The default is 0.
9. (Optional) Set the Maximum Transmission Units (MTU) of network packets using this route:
(config network route static 0)> mtu integer
(config network route static 0)>
10. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Delete a static route


WebUI
Digi Connect EZ 4/4i User Guide
IP routing
314