Connect Ez 4I Only: Review Installation Instructions For Hazardous Locations; Step 1: Verify Product Components; Included Equipment For Connect Ez 4/4I - Digi Connect EZ 4 User Manual

Hide thumbs Also See for Connect EZ 4:
Table of Contents

Advertisement

Get started with Connect EZ 4/4i
Connect EZ 4i ONLY: Review installation instructions for
hazardous locations
This information is intended for these Connect EZ 4i models:
Ethernet Gateway: Model 50002072-03 and 50002072-06
n
Before you begin installing your Connect EZ 4i device, please review these installation instructions for
hazardous locations.
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D OR non-hazardous
n
locations only.
All external or field wiring must be in accordance to NFPA 70 Article 501.10(B).
n
The unit is intended for fixed installations.
n
This equipment is considered open type, only accessible by the use of a tool.
n
Antenna connections provide non-incendive energy levels for use in Class I, Division 2, Groups
n
A, B, C and D, Hazardous Locations. Install in accordance with Control Document No.
90002470-88 A.

Step 1: Verify product components

Verify that you have the following included equipment.
NEXT STEP: If you are performing the initial device set-up, proceed to the next step after verifying the
components:
Connect the Wi-Fi

Included equipment for Connect EZ 4/4i

Equipment
Description
Connect EZ
For detailed information about the panels, see:
4
Connect EZ
4i
Note
jack. (Part number 18000724)
Power
Connect EZ 4 is intended to be powered by a locking barrel output transformer rated
supply
100-240 VAC to 12 VDC, and with a 3 A output.
(Connect EZ
Use the included power supply (part number 24000136).
For information about connecting the power supply, see
4)
supply.
Power
Connect EZ 4i is intended to be powered by a certified extended temperature power
supply
supply pigtail DC cable with output rated at 100-240 VAC to 12 VDC 3 A, -40 C to +74
Digi Connect EZ 4/4i User Guide

Connect EZ 4i ONLY: Review installation instructions for hazardous locations

antenna.
Front panel and LEDs
n
Back panel
n
Bottom panel
n
Connect EZ 4i only: An industrial power connector is attached to the power
Step 2: Connect the power
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Connect ez 4i

Table of Contents