Table of Contents
Advertisement
Wi-Fi
If DFS functionality is enabled, the Connect EZ must be rebooted after saving the configuration
changes to re-initialize the Wi-Fi module.
Note
If DFS functionality is enabled, any access points enabled on the Connect EZ device will not be
started.
Required configuration items
Enable DFS support.
n
One or more configured Wi-Fi clients. See
n
details.
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > WiFi.
4. For Frequency band, select 5 GHz.
5. Click to enable DFS Client Support.
Note
When DFS Client Support is enabled, any enabled access points that use this radio will
not be started and cannot be used as access points.
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
Digi Connect EZ 4/4i User Guide
Configure the Wi-Fi radio to support DFS channels in client mode
Configure a Wi-Fi client and add client networks
for
220
Advertisement
Table of Contents
