Digi Connect EZ 4 User Manual page 342

Routing
(config)> show network vrrp VRRP_test interface
/network/interface/eth2
(config)>
ii. Enable SureLink on the interface:
(config)> network interface eth2 ipv4 surelink enable true
(config)>
iii. Set the amount of time to wait between connectivity tests:
(config)> network interface eth2 ipv4 surelink interval value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set interval to ten minutes, enter 5s:
(config)> network interface eth2 ipv4 surelink interval 5s
(config)>
iv. Create a SureLink test target:
(config)> add network interface eth2 ipv4 surelink target end
(config network interface eth2 ipv4 surelink target 0)>
v. Configure the type of test for the test target:
(config network interface eth2 ipv4 surelink target 0)> test value
(config network interface eth2 ipv4 surelink target 0)>
where value is one of:
Digi Connect EZ 4/4i User Guide
ping: Tests connectivity by sending an ICMP echo request to a specified
n
hostname or IP address.
Specify the hostname or IP address:
l
(config network interface eth2 ipv4 surelink target 0)>
ping_host host
(config network interface eth2 ipv4 surelink target 0)>
(Optional) Set the size, in bytes, of the ping packet:
l
(config network interface eth2 ipv4 surelink target 0)>
ping_size [num]
(config network interface eth2 ipv4 surelink target 0)>
dns: Tests connectivity by sending a DNS query to the specified DNS server.
n
Specify the DNS server. Allowed value is the IP address of the DNS server.
l
Virtual Router Redundancy Protocol (VRRP)
342