Step 3: Connect To Site Network Using An Ethernet Lan; Step 4: Connect The Device To The Network Using Wi-Fi; Connect The Wi-Fi Antenna; Enable Wi-Fi - Digi Connect EZ 4 User Manual

Hide thumbs Also See for Connect EZ 4:

Table of Contents

Get started with Connect EZ 4/4i

Step 3: Connect to site network using an Ethernet LAN

This section explains how to connect to a site network using an Ethernet cable.

1. Connect one end of an Ethernet cable to your site network.

2. Connect the other end of the Ethernet cable to the Ethernet port on the Connect EZ. By

default a DHCP request will be sent to the local Ethernet network.

If you do not have a DHCP server on your network, you can connect locally over 192.168.210.1.

Using the web

NEXT STEP: If you are performing the initial device set-up, proceed to the next step:

the device to the network using

You can use a Wi-Fi connection to connect the Connect EZ to your network. This enables you to access

the device's web UI and configure it.

NEXT STEP: If you are performing the initial device set-up, after you have configure Wi-Fi you can

proceed to the next step:

This section explains how to connect the Wi-Fi antenna to the Connect EZ hardware.

1. Orient the device so the top panel faces you.

2. Attach the included Wi-Fi antenna to the device. While gripping the metal connector section

with your thumb and forefinger, tighten until secure. Do not tighten the antenna by holding

any part of the plastic antenna housing.

NEXT STEP: Continue with the process:

For more detailed information, see

1. Log into the Connect EZ WebUI as a user with full Admin access rights.

2. On the menu, click System. Under Configuration, click Device Configuration. The

Configuration window is displayed.

3. Click Network > WiFi.

4. Click Enable to enable Wi-Fi.

5. Click Apply to save the configuration and apply the change.

NEXT STEP: Continue with the process:

Digi Connect EZ 4/4i User Guide

Step 5: Discover the IP address using the Digi

Configure the Wi-Fi radio's

Configure Wi-Fi on the

Step 3: Connect to site network using an Ethernet LAN

Step 4: Connect

Connect ez 4i