Table of Contents
Advertisement
Services
c. For Address, enter the IPv6 address or network that can access the device's telnet
d. Click again to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the Connect EZ
n
device:
a. Click Interfaces.
b. For Add Interface, click .
c. For Interface, select the appropriate interface from the dropdown.
d. Click again to allow access through additional interfaces.
To limit access based on firewall zones:
n
a. Click Zones.
b. For Add Zone, click .
c. For Zone, select the appropriate firewall zone from the dropdown.
d. Click again to allow access through additional firewall zones.
6. Multicast DNS (mDNS) is disabled by default. mDNS is a protocol that resolves host names in
small networks that do not have a DNS server. To enable mDNS, click Enable mDNS.
7. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service telnet acl address end value
(config)>
Where value can be:
Digi Connect EZ 4/4i User Guide
service. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the telnet service.
l
See
Firewall configuration
for information about firewall zones.
Configure telnet access
511
Advertisement
Table of Contents
