Table of Contents
Advertisement
Configuration and management
Review Connect EZ default settings
You can review the default settings for your Connect EZ device by using the local WebUI or Digi
Remote Manager:
Local WebUI
1. Log into the Connect EZ WebUI as a user with Admin access.
2. On the menu, click System > Device Configuration.
Digi Remote Manager
1. If you have not already done so, connect to your Digi Remote Manager account.
2. Click Device Management to display a list of your devices.
3. Locate and select your device as described in
your
device.
4. Click Configure.
The following tables list important factory default settings for the Connect EZ.
Default interface configuration
Interface type
Wide Area Networks (WANs)
Ethernet Network
Digi Connect EZ 4/4i User Guide
Use Digi Remote Manager to view and manage
Preconfigured
interfaces
Devices
Modem
WWAN1
n
n
cellular
modem
ETH1
Ethernet:
n
n
ETH1
ETH2
Ethernet:
n
n
ETH2
Loopback
Ethernet:
n
n
Loopback
Default IP
Ethernet:
n
n
ETH1
Default Link-
Ethernet:
n
n
local IP
ETH1
Review Connect EZ default settings
Default configuration
Firewall zone: External
n
WAN priority: Metric=3
n
SIM failover after 5
n
attempts
Firewall zone: Edge
n
DHCP client enabled
n
Firewall zone: Edge
n
DHCP client enabled
n
Firewall zone:
n
Loopback
IP address: 127.0.0.1/8
n
Firewall zone: Setup
n
IP address
n
192.168.210.1/24
Firewall zone: Setup
n
IP address
n
169.254.100.100/16
43
Advertisement
Table of Contents
