Save Captured Data Traffic To A File - Digi Connect EZ 4 User Manual

Diagnostics
Checksum
Urgent Pointer
TCP Data
00 00 00 00 00 00
>
where capture_filter is the name of a packet capture configuration. See
capture for the network analyzer
To determine available packet capture configurations, use the ?:
> show anaylzer name ?
name: Name of the capture filter to use.
Format:
test_capture
capture_ping
> show anaylzer name

Save captured data traffic to a file

Data traffic is captured to RAM and when the device reboots, the data is lost. To retain the captured
data, first save the data to a file and then upload the file to a PC.
To save captured traffic data to a file, use the

Command line
1. Log into the Connect EZ command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Type the following at the Admin CLI prompt:
> analyzer save filename filename name capture_filter
>
where:
filename is the name of the file that the captured data will be saved to.
n
Determine filenames already in use:
Use the tab autocomplete feature to determine filenames that are currently in use:
> analyzer save name <tab>
test1_analyzer_capture
> analyzer save name
capture_filter is the name of a packet capture configuration. See
n
capture for the network analyzer
To determine available packet capture configurations, use the ?:
Digi Connect EZ 4/4i User Guide
: 0xc740
: 0
for more information.
analyzer save command:
test2_analyzer_capture
for more information.
Analyze network traffic
......
Configure packet
Configure packet
853