Digi Connect EZ 4 User Manual page 222

Wi-Fi
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set channel for the radio:
a. Set the band for the radio:
(config)> network wifi radio phy0 band value
(config)>
where value is either 2400mhz or 5000mhz.
b. Set the mode for the Wi-Fi radio. For example:
n
n
Digi Connect EZ 4/4i User Guide
If the Wi-Fi radio has a band of 2400mhz:
(config)> network wifi radio phy0 2400mhz mode value
(config)>
where value is one of b, bg, bgn, g, gn, or n.
If the Wi-Fi radio has a band of 5000mhz:
(config)> network wifi radio phy0 5000mhz mode value
(config)>
where value is one of ac, acn, or n.
Configure the Wi-Fi radio's band and protocol
222